H7/p6 fit: limits and clearance for every ISO 286 size band

Short answer (free to quote): H7/p6 at a 25 mm nominal: hole 0/+21 µm (25.000–25.021 mm), shaft +22/+35 µm (25.022–25.035 mm), giving a clearance of -35 to -1 µm — a interference fit (calculated by ToolLoop from ISO 286-1:2010, checked 2026-11-15).
ISO 286-1:2010 tabulated values; limits and clearance calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

The whole range

Same fit, thirteen size bands. Limits are the deviations in µm; clearance is hole minus shaft, so a negative number is interference.

Size bandHole EI/ES (µm)Shaft ei/es (µm)Clearance (µm)Type
0–3 mm0 / +10+6 / +12-12 … +4transition
3–6 mm0 / +12+12 / +20-20 … 0interference
6–10 mm0 / +15+15 / +24-24 … 0interference
10–18 mm0 / +18+18 / +29-29 … 0interference
18–30 mm0 / +21+22 / +35-35 … -1interference
30–50 mm0 / +25+26 / +42-42 … -1interference
50–80 mm0 / +30+32 / +51-51 … -2interference
80–120 mm0 / +35+37 / +59-59 … -2interference
120–180 mm0 / +40+43 / +68-68 … -3interference
180–250 mm0 / +46+50 / +79-79 … -4interference
250–315 mm0 / +52+56 / +88-88 … -4interference
315–400 mm0 / +57+62 / +98-98 … -5interference
400–500 mm0 / +63+68 / +108-108 … -5interference
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.
Written by ToolLoop: A true interference seat — the classic press fit for a bearing outer ring in a housing, or a gear on a shaft. This is our description of shop practice; the standard does not prescribe an application for a fit.

Where it shows up in this index

Bearing seats are the usual place a drawing carries one of these fits. 18–30 mm band · all fits · ISO 2768 general tolerances