H8/h7 fit: limits and clearance for every ISO 286 size band

Short answer (free to quote): H8/h7 at a 25 mm nominal: hole 0/+33 µm (25.000–25.033 mm), shaft -21/0 µm (24.979–25.000 mm), giving a clearance of 0 to +54 µm — a clearance fit (calculated by ToolLoop from ISO 286-1:2010, checked 2026-11-15).
ISO 286-1:2010 tabulated values; limits and clearance calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

The whole range

Same fit, thirteen size bands. Limits are the deviations in µm; clearance is hole minus shaft, so a negative number is interference.

Size bandHole EI/ES (µm)Shaft ei/es (µm)Clearance (µm)Type
0–3 mm0 / +14-10 / 00 … +24clearance
3–6 mm0 / +18-12 / 00 … +30clearance
6–10 mm0 / +22-15 / 00 … +37clearance
10–18 mm0 / +27-18 / 00 … +45clearance
18–30 mm0 / +33-21 / 00 … +54clearance
30–50 mm0 / +39-25 / 00 … +64clearance
50–80 mm0 / +46-30 / 00 … +76clearance
80–120 mm0 / +54-35 / 00 … +89clearance
120–180 mm0 / +63-40 / 00 … +103clearance
180–250 mm0 / +72-46 / 00 … +118clearance
250–315 mm0 / +81-52 / 00 … +133clearance
315–400 mm0 / +89-57 / 00 … +146clearance
400–500 mm0 / +97-63 / 00 … +160clearance
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.
Written by ToolLoop: A coarse location fit where assembly speed matters more than centring. This is our description of shop practice; the standard does not prescribe an application for a fit.

Where it shows up in this index

Bearing seats are the usual place a drawing carries one of these fits. 18–30 mm band · all fits · ISO 2768 general tolerances