H9/d9 fit: limits and clearance for every ISO 286 size band

Short answer (free to quote): H9/d9 at a 25 mm nominal: hole 0/+52 µm (25.000–25.052 mm), shaft -117/-65 µm (24.883–24.935 mm), giving a clearance of +65 to +169 µm — a clearance fit (calculated by ToolLoop from ISO 286-1:2010, checked 2026-11-15).
ISO 286-1:2010 tabulated values; limits and clearance calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

The whole range

Same fit, thirteen size bands. Limits are the deviations in µm; clearance is hole minus shaft, so a negative number is interference.

Size bandHole EI/ES (µm)Shaft ei/es (µm)Clearance (µm)Type
0–3 mm0 / +25-45 / -20+20 … +70clearance
3–6 mm0 / +30-60 / -30+30 … +90clearance
6–10 mm0 / +36-76 / -40+40 … +112clearance
10–18 mm0 / +43-93 / -50+50 … +136clearance
18–30 mm0 / +52-117 / -65+65 … +169clearance
30–50 mm0 / +62-142 / -80+80 … +204clearance
50–80 mm0 / +74-174 / -100+100 … +248clearance
80–120 mm0 / +87-207 / -120+120 … +294clearance
120–180 mm0 / +100-245 / -145+145 … +345clearance
180–250 mm0 / +115-285 / -170+170 … +400clearance
250–315 mm0 / +130-320 / -190+190 … +450clearance
315–400 mm0 / +140-350 / -210+210 … +490clearance
400–500 mm0 / +155-385 / -230+230 … +540clearance
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.
Written by ToolLoop: Very loose: covers machining error in welded or cast structures. This is our description of shop practice; the standard does not prescribe an application for a fit.

Where it shows up in this index

Bearing seats are the usual place a drawing carries one of these fits. 18–30 mm band · all fits · ISO 2768 general tolerances