H11 hole tolerance: EI/ES in µm for every size band

Short answer (free to quote): H11 is a hole tolerance: the lower deviation is zero and the upper deviation is the full IT11 width. At 25 mm that is 0 to +130 µm, i.e. a bore from 25.000 to 25.130 mm (ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated values; compiled by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

By size band

Size bandEI (µm)ES (µm)Width (µm)Hole limits at midpoint (mm)
0–3 mm0+60601.500–1.560
3–6 mm0+75757.500–4.575
6–10 mm0+909014.000–8.090
10–18 mm0+11011024.000–14.110
18–30 mm0+13013042.000–24.130
30–50 mm0+16016070.000–40.160
50–80 mm0+190190115.000–65.190
80–120 mm0+220220180.000–100.220
120–180 mm0+250250270.000–150.250
180–250 mm0+290290395.000–215.290
250–315 mm0+320320532.500–282.820
315–400 mm0+360360672.500–357.860
400–500 mm0+400400850.000–450.400
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

A capital letter is a hole, a lower-case letter a shaft; H is the hole that the whole hole-basis fit system is built on. See all fits.