H8 hole tolerance: EI/ES in µm for every size band

Short answer (free to quote): H8 is a hole tolerance: the lower deviation is zero and the upper deviation is the full IT8 width. At 25 mm that is 0 to +33 µm, i.e. a bore from 25.000 to 25.033 mm (ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated values; compiled by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

By size band

Size bandEI (µm)ES (µm)Width (µm)Hole limits at midpoint (mm)
0–3 mm0+14141.500–1.514
3–6 mm0+18187.500–4.518
6–10 mm0+222214.000–8.022
10–18 mm0+272724.000–14.027
18–30 mm0+333342.000–24.033
30–50 mm0+393970.000–40.039
50–80 mm0+4646115.000–65.046
80–120 mm0+5454180.000–100.054
120–180 mm0+6363270.000–150.063
180–250 mm0+7272395.000–215.072
250–315 mm0+8181532.500–282.581
315–400 mm0+8989672.500–357.589
400–500 mm0+9797850.000–450.097
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

A capital letter is a hole, a lower-case letter a shaft; H is the hole that the whole hole-basis fit system is built on. See all fits.