c11 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): c11 at a 25 mm nominal is -110/-240 µm, i.e. a shaft between 24.760 and 24.890 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm-60-120601.380–1.440
3–6 mm-70-145754.355–4.430
6–10 mm-80-170907.830–7.920
10–18 mm-95-20511013.795–13.905
18–30 mm-110-24013023.760–23.890
30–50 mm-120-28016039.720–39.880
50–80 mm-140-33019064.670–64.860
80–120 mm-170-39022099.610–99.830
120–180 mm-210-460250149.540–149.790
180–250 mm-260-550290214.450–214.740
250–315 mm-330-650320281.850–282.170
315–400 mm-400-760360356.740–357.100
400–500 mm-440-840400449.160–449.560
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H11/c11 · ISO 286 overview · ISO 2768