d9 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): d9 at a 25 mm nominal is -65/-117 µm, i.e. a shaft between 24.883 and 24.935 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm-20-45251.455–1.480
3–6 mm-30-60304.440–4.470
6–10 mm-40-76367.924–7.960
10–18 mm-50-934313.907–13.950
18–30 mm-65-1175223.883–23.935
30–50 mm-80-1426239.858–39.920
50–80 mm-100-1747464.826–64.900
80–120 mm-120-2078799.793–99.880
120–180 mm-145-245100149.755–149.855
180–250 mm-170-285115214.715–214.830
250–315 mm-190-320130282.180–282.310
315–400 mm-210-350140357.150–357.290
400–500 mm-230-385155449.615–449.770
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/d9 · ISO 286 overview · ISO 2768