m6 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): m6 at a 25 mm nominal is +21/+8 µm, i.e. a shaft between 25.008 and 25.021 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm+8+261.502–1.508
3–6 mm+12+484.504–4.512
6–10 mm+15+698.006–8.015
10–18 mm+18+71114.007–14.018
18–30 mm+21+81324.008–24.021
30–50 mm+25+91640.009–40.025
50–80 mm+30+111965.011–65.030
80–120 mm+35+1322100.013–100.035
120–180 mm+40+1525150.015–150.040
180–250 mm+46+1729215.017–215.046
250–315 mm+52+2032282.520–282.552
315–400 mm+57+2136357.521–357.557
400–500 mm+63+2340450.023–450.063
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/m6 · ISO 286 overview · ISO 2768