s6 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): s6 at a 25 mm nominal is +48/+35 µm, i.e. a shaft between 25.035 and 25.048 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm+20+1461.514–1.520
3–6 mm+27+1984.519–4.527
6–10 mm+32+2398.023–8.032
10–18 mm+39+281114.028–14.039
18–30 mm+48+351324.035–24.048
30–50 mm+59+431640.043–40.059
50–80 mm+72+531965.053–65.072
80–120 mm+93+7122100.071–100.093
120–180 mm+125+10025150.100–150.125
180–250 mm+159+13029215.130–215.159
250–315 mm+202+17032282.670–282.702
315–400 mm+244+20836357.708–357.744
400–500 mm+272+23240450.232–450.272
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/s6 · ISO 286 overview · ISO 2768