e8 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): e8 at a 25 mm nominal is -40/-73 µm, i.e. a shaft between 24.927 and 24.960 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm-14-28141.472–1.486
3–6 mm-20-38184.462–4.480
6–10 mm-25-47227.953–7.975
10–18 mm-32-592713.941–13.968
18–30 mm-40-733323.927–23.960
30–50 mm-50-893939.911–39.950
50–80 mm-60-1064664.894–64.940
80–120 mm-72-1265499.874–99.928
120–180 mm-85-14863149.852–149.915
180–250 mm-100-17272214.828–214.900
250–315 mm-110-19181282.309–282.390
315–400 mm-125-21489357.286–357.375
400–500 mm-135-23297449.768–449.865
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/e8 · ISO 286 overview · ISO 2768