g6 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): g6 at a 25 mm nominal is -7/-20 µm, i.e. a shaft between 24.980 and 24.993 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm-2-861.492–1.498
3–6 mm-4-1284.488–4.496
6–10 mm-5-1497.986–7.995
10–18 mm-6-171113.983–13.994
18–30 mm-7-201323.980–23.993
30–50 mm-9-251639.975–39.991
50–80 mm-10-291964.971–64.990
80–120 mm-12-342299.966–99.988
120–180 mm-14-3925149.961–149.986
180–250 mm-15-4429214.956–214.985
250–315 mm-17-4932282.451–282.483
315–400 mm-18-5436357.446–357.482
400–500 mm-20-6040449.940–449.980
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/g6 · ISO 286 overview · ISO 2768