k6 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): k6 at a 25 mm nominal is +15/+2 µm, i.e. a shaft between 25.002 and 25.015 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm+6061.500–1.506
3–6 mm+9+184.501–4.509
6–10 mm+10+198.001–8.010
10–18 mm+12+11114.001–14.012
18–30 mm+15+21324.002–24.015
30–50 mm+18+21640.002–40.018
50–80 mm+21+21965.002–65.021
80–120 mm+25+322100.003–100.025
120–180 mm+28+325150.003–150.028
180–250 mm+33+429215.004–215.033
250–315 mm+36+432282.504–282.536
315–400 mm+40+436357.504–357.540
400–500 mm+45+540450.005–450.045
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/k6 · ISO 286 overview · ISO 2768