n6 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): n6 at a 25 mm nominal is +28/+15 µm, i.e. a shaft between 25.015 and 25.028 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm+10+461.504–1.510
3–6 mm+16+884.508–4.516
6–10 mm+19+1098.010–8.019
10–18 mm+23+121114.012–14.023
18–30 mm+28+151324.015–24.028
30–50 mm+33+171640.017–40.033
50–80 mm+39+201965.020–65.039
80–120 mm+45+2322100.023–100.045
120–180 mm+52+2725150.027–150.052
180–250 mm+60+3129215.031–215.060
250–315 mm+66+3432282.534–282.566
315–400 mm+73+3736357.537–357.573
400–500 mm+80+4040450.040–450.080
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/n6 · ISO 286 overview · ISO 2768