p6 shaft tolerance: deviations in µm for every size band

Short answer (free to quote): p6 at a 25 mm nominal is +35/+22 µm, i.e. a shaft between 25.022 and 25.035 mm (calculated by ToolLoop from ISO 286-1:2010 tables, checked 2026-11-15).
ISO 286-1:2010 tabulated deviations; limits calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

Deviations and limits by size band

Size bandes (µm)ei (µm)Width (µm)Limit sizes at band midpoint (mm)
0–3 mm+12+661.506–1.512
3–6 mm+20+1284.512–4.520
6–10 mm+24+1598.015–8.024
10–18 mm+29+181114.018–14.029
18–30 mm+35+221324.022–24.035
30–50 mm+42+261640.026–40.042
50–80 mm+51+321965.032–65.051
80–120 mm+59+3722100.037–100.059
120–180 mm+68+4325150.043–150.068
180–250 mm+79+5029215.050–215.079
250–315 mm+88+5632282.556–282.588
315–400 mm+98+6236357.562–357.598
400–500 mm+108+6840450.068–450.108
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.

Shaft deviations are measured from the nominal size: es is the upper, ei the lower. The width always equals the IT grade for that band.

See also: H7/p6 · ISO 286 overview · ISO 2768